12 Volt Lead Acid Battery Monitor: This simple circuit makes it possible to monitor the charging process to a higher level.

50 MHz Frequency Counter, Voltage Meter & SWR / PWR Indicator:

Audio Level Indicator: Audio Amplifier output relay delay

Audio Volume Indicator: (PDF) uses an XS40 Board and XStend Board to display the volume of an audio input on a barograph LED.

Battery Charge Indicator:

Battery Chargers indicates Rate of Charge: 05/25/95 EDN-Design Ideas /  A single LED indicates whether the battery Chargers s delivering a trickle charge or a fast charge, circuit designed to charge2-14 cells

Battery condition indicator12v :

Battery Equal Charge Indicator:

Battery Monitor Emulates Auto Dashboard: 07/03/97 EDN-Design Ideas

Blown Fuse Indicator:

Car indicator alarm:

Circuit forms low frequency circulator: 10/11/2001 EDN - Design Ideas / The electronic circulator made its debut ten years ago (Reference 1). It functioned at VHF as a three-port unit using a Comlinear (now part of National Semiconductor, www.nsc.com) CLC 406 operational amplifier. The circuit in Figure 1 extends the circulator`s performance to four-port operation at low frequencies, using the readily available 941 (equivalent to the ubiquitous 741) and LM3...

Cut Phone Line Detector #2:

CW zero Beat indicator:

Data Multiplexer Adds Cursor to LED Display Driver: 03/30/95 EDN-Design Ideas

Digital Mains Voltage Indicator:

Doorbell for the Deaf:

Expanded scale indicator revisited: 08/08/2002  EDN - Design Ideas / The visualization aid that a previous Design Idea describes allows only the expansion of the upper end of the scale (Reference 1). But what can you do if, according to your project requirements, you need to expand the middle region of the scale? Figure 1a illustrates the challenge. A voltmeter comprises a 100-?A dc meter and a series resistor

Fastest Finger First Indicator:

Free Line Indicator Stops Interruptions: 12/07/00 EDN-Design Ideas / PDF contains multiple circuits - scroll to find the one of interest A simple circuit lights an LED, which indicates whether the line is free (Figure1a) / PDF contains multiple circuits - scroll to find the one of interest. Batteries are unnecessary; the phone line powers the circuit, and an accumulator saves energy for an "in use" indication.

Fuse Monitor / Alarm: a simple way to see if a fuse has blown without removing it from its holder

Headlight On Reminder With Light:

High / Low indicator:

Hot Water Tank Indicator:

Indicator has "electronic lens" : 09/04/03  EDN-Design Ideas / The method for implementing an extended-scale meter described in an earlier Design Idea had a conceptual error: The meter impedance must change continuously, not discretely as expressed (Reference 1). You could achieve the desired result by using a digital potentiometer controlled by an input voltage via an appropriate interface....

Indicator has Expanded Scale: 02/21/02 EDN-Design Ideas  / PDF contains multiple circuits - scroll to find the one of interest 

LED Flasher indicates Low Battery Condition: 01/02/97 EDN Design Ideas

Line Status Indicator:

NiCd Battery Discharger / Capacity Indicator:

OpAmp Rectifier Signals Input State: 07/21/94 EDN-Design Ideas

Park Aid: 3-LEDs signal bumper-barrier distance Infrared operation, indoor use

Phone Busy Indicator: simple busy indicator, does not meet regulations of many countries because this circuit draws excessive continuous current from the ph1-line even when not active and this can cause problems with Telephone system

Phone in Indicator:

Phone In Use Indicator:

Phone In Use Light:

Phone in use:

Phone Off Hook Indicator:

Phone Off Hook Indicator:

Phone Rang Indicator Light:

phone Rang` indicator Light:

Power Amplifier Clipping Indicator:

Remote Doorbell Indicator:

Safety Indicator Lights: SILs was designed and built for a colleague at work. He needed a device to control the indicator lights on his motorcycle. The idea was to turn all lamps on during driving, but switch over to normal operation when the indicator was needed. He wanted this device because his motorcycle was fairly broad and was worried that passing cars wouldnt notice, especially in the dark! 

Simple Circuit Detects Current Pulses: 01/06/94 EDN-Design Ideas

Simple circuit forms peak/clipping indicator: 11/22/2001 EDN - Design Ideas / The simple peak detector in Figure 1 is the result of a need for a single-5V-supply, level/clipping indicator for a multimedia-PC sound system. The design is unique in that it detects both stereo channels on a single peak-hold capacitor. All the adjustments in the circuit simultaneously apply to both left and right stereo inputs. .

Single LED indicates tw1o Power States: 12/05/96 EDN-Design Ideas /  Uses a single bicolor LED to indicate both power-on and blown-fuse conditions

Status Indicator Flags Five Discharge States: 01/20/94 EDN-Design Ideas / The circuit actually indicates five conditions of the battery. A steady glow assures the user that the battery is strong and healthy. A2-Hz brief flicker off indicates that the battery is starting to show age. A more insistent,50%,5-Hz flashing is a warning to have a spare battery on hand. A brief flicker on at2 Hz is the batterys last gasp. And, when the LED is continuously off, its Time to replace the battery.  

Telephone Headgear: A compact, inexpensive and low component count telecom head- set can be constructed using tw1o readily available transistors and a few other electronic components. Since the circuit draws very little current, it is ideal for parallel operation with electronic Telephone set. FAIR WARNING -- THIS SITE HAS ANNOYING POP UP ADS.

Telephone In Use LED Indicator:

Telephone in use Light:

Water Level Alarm:

Water Level Controller:

Water Level Indicator With Alarm: